You are here: Webhelp 5.5R7 > Monitor > Alarm > Alarm Rule

Alarm Rule

This feature may not be available on all platforms. Please check your system's actual page if your device delivers this feature.

An alarm rule defines the condition which triggers an alarm. When an incident that complies with the alarm rule happens, system will detect that incident and generate an alarm message.

There are three alarm categories: device alarms, application alarms and network service alarms.

Configuring Interface Bandwidth

If you intend to use the interface alarm rule, make sure that you have configured the interface bandwidth. Both are indispensable, otherwise you will not receive the alarms.

To configure the detection rule, take the following steps:

  1. Click System> Alarm Rule > Rule.
  2. Click Interface Bandwidth Configuration at the top-right corner.
  3. In Interface dialog box, click Add.
  4. Click OK.

Creating an Alarm Rule

To create an alarm rule, take the following steps:

  1. Select System > Alarm Rule.
  2. Click New.

  3. Click OK.