Destination interface route is designed to select a route and forward data based on the Destination IP address and ingress interface of a packet.
Creating a Destination-Interface Route
To create a Destination-Interface route, take the following steps:
- Select Network > Routing > Destination Interface Route.
- Select the IPv4 or IPv6 tab page, and create an IPv4 Destination-Interface route or IPv6 Destination-Interface route on the corresponding page. This step is only applicable for IPv6 version.
- Click New.
In the Destination Interface Route Configuration page, enter values.
Option Description Virtual Router From the Virtual Router drop-down list, select the Virtual Routerouter for the new route. The default value is "trust-vr". Ingress Interface Select an interface for the route from the drop-down list. Destination IP Type the Destination IP for the route into the textbox. Netmask Type the corresponding subnet mask into the textbox. Next-hop To specify the type of next hop, click Gateway, Virtual Router in current Vsys, Interface , or Virtual Router in other Vsys.
- Gateway: Type the IP address into the Gateway text box.
- Virtual Router in current Vsys: Select a name from the Virtual Router drop-down list.
- Interface: Select a name from the Interface drop-down list. Type the IP address into the Gateway text box. For a tunnel interface, you need to type the gateway address for the tunnel's peer in the optional box below.
- Virtual Router in other Vsys: Select a name from the Vsys drop-down list. Select a name from the Virtual Router drop-down list.
Schedule Specifies a schedule when the rule will take effect. Select a desired schedule from the Schedule drop-down list. After selecting the desired schedules, click the blank area in this dialog to complete the schedule configuration.
To create a new schedule, click New Schedule.
Precedence Type the route precedence into the textbox. The smaller the parameter is, the higher the precedence is. If multiple routes are available, the route with higher precedence will be prioritized. The value range is 1 to 255. The default value is 1. When the value is set to 255, the route will be invalid. Weight Type the weight for the DIBR into the textbox. This parameter is used to determine the weight of traffic forwarding in load balance. The value range is 1 to 255. The default value is 1. Description Type the description information into the Description text box if necessary.
- Click OK.